C. SETTING THE SERVICE DOOR FUNCTIONS
a) Press and hold the
SET
button until the display shows "1", then press
the UP button until the display shows
"C".
b) Press the
SET
button again. The device is now in the service door
switch type selection mode. The display will show the number
"0"
with a
flashing dot.
c) Press
UP / DOWN
button once to set the service door switch type. You
can choose "0" or "1".
The number "0" means that the service door safety switch is normally
open.
The number "1" means that the service door safety switch is normally
closed.
e) Press the
SET
button to confirm the settings, the drive will automatically
go back to standby state and display "ll".
ATTENTION! The service door safety switch type is by default set to "0".
D. PHOTOCELL ON / OFF
ATTENTION! Make sure that the photocell has been properly installed and is
operating in normally closed contact mode.
Also note that the photocell function must be disabled if not fitted, otherwise the
door cannot be closed and the
LED
display will show the letter
"r"
as an
indication.
a) Press and hold the
SET
button until the display shows "1", then press the
UP
button until the display shows "d".
b) Press the
SET
button again. The device is now in the photocell
ON / OFF
setting mode. The display will show the number "0" with a flashing dot.
c) Press the
UP / DOWN
button once to set the photocell
ON / OFF
switch. You
can choose "0" or "1".
d)
The number "0" means that the photocell function is disabled.
The number "1" means that the photocell function is on.
d) Press the
SET
button to confirm the settings and the drive will automatically go
back to the ready state and display "ll".
ATTENTION! The photocell function is set to "0" by default.
19
Содержание 300 SILENT 1000N
Страница 28: ...DISTRIBUTOR 28...
