HATO 300 SILENT 1000N, Руководство по эксплуатации

Страница: 13 / 29

4. AUTOMATIC CLOSURE AND TIME SETTING
NOTE: We recommend the use of photocells in any installation where the
automatic closure function is enabled.
a) Press and hold the SET button until the display shows "1", then press
the UP button until the display shows "4"
b) Press the SET button again, the device is now in the automatic closing
adjustment mode. The number "0" will appear on the display. with a dot
that blinks.
c) Press
UP / DOWN button once to set auto close time (0 ~ 9).
d) Press the UP button to increase the time or DOWN button to decrease
the time.
The closing time is 15 seconds * N, N = 0 ~ 9. The maximum time is
135 seconds. To disable the auto close function, set the time to zero
(0).
e) Press the SET button to confirm the settings, and the drive will
automatically go back to the ready state and display "ll".
ATTENTION!
1. The closing time is factory-set to "0".
2. If the photocell function is turned on and there is an obstacle, the
automatic closure time will be stopped and the countdown will start
again when the obstacle is removed.
3. SETTING THE TRAVEL SPEED
NOTE: If you change the speed, it will override the previous limit switch
settings. It is necessary to readjust the end positions.
a) Press and hold the SET button until the display shows "1", then press
the UP button until the display shows "3.
b) Press the SET button again. The device is now in speed regulation
mode. Then the letter "A" will appear on the display with a dot which will
flash on the display.
c) Press UP / DOWN button to select speed. The number "8" represents
80% of the driving speed. The letter "A" stands for full speed.
d) Press the SET button to confirm the setting, then it will return to
standby status automatically and display "ll".
ATTENTION! The travel speed is factory-set to full speed "A".
13