ASSEMBLY INSTRUCTIONS (CONT.)
10
Figure 8
H5 Bolt
H7
Washer
P15
Note: Hinge
Gear Assemblies
Must Mesh
Note: This Hinge is Threaded and Must Be on Inside
CAUTION:
Pinch Point
CAUTION:
Pinch Point
P5
P5
Reset Button
Reset
Button
No Gap
No Gap
Ligature
Bundle of
White Wire
P16
Hinge Set
P16
Hinge Set
P7R
Back Side
Apron
P6R
Front Side
Apron
Note: This Hinge is NOT Threaded
and Must Be on Outside
H7
Washer
18. With the help of another adult, set both completed assemblies upright and position so gears face each other as shown
in Figure 8. Using (2) HINGE SETS, P16, connect assemblies using BOLT, H5, and Washer, H7, as shown in Figure 8.
The bolts should be snug, but NOT over tightened as this is a pivot area.
Note: Hinge gear assemblies must mesh together,
per diagram, and there should be no gap between playfields. Also, only one hinge plate per set is threaded and must be
installed on the inside of each playfield side.
20. Place TARGET BOARD, P15, with red hole at the top, into position with the sides resting in the grooves of the braces
on the side panels and against the front of the ramp.
21. Attach the RESET BUTTON, with the long white wire, through the hole in the FRONT END APRON, P5, by removing
the washer and nut on the back of the Reset Button, feeding the Reset Button and wire through the hole from the front and
re-attaching the washer and nut.
Note: Be careful not to damage or break wire connections while attaching Reset Button.
Reset Button -
(this ships
pre-wired to
Target Board)
P24
P24
19. Attach TRIANGULAR PATCH, P24, on each side aprons using (2) BOLTS, H4, and (2) WASHERS, H6, on each patch,
as shown in Figure 8.
H4
H6
CAUTION:
Be careful when opening Reset Button to attach
to the table that you don’t lose
small spring
.
The switch will NOT work without it.
NOTE: When screwing switch pieces
together, place nut over button half
and turn switch clockwise onto the piece
with wires to avoid damage to wires.
