Hatco Serv-Rite SRB-1, Инструкция по установке и эксплуатации

Страница: 11 / 16

Form No. SRM-0608 9
MAINTENANCE
Replacing the Heat Lamps
Use the following procedure to change the halogen
heat lamps in SRBW-1 and SRGBW-1 models.
Use only Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine Hatco
Replacement Parts will void all warranties and
may subject operators of the equipment to
hazardous electrical voltage, resulting in
electrical shock or burn. Genuine Hatco
Replacement Parts are specified to operate safely
in the environments in which they are used. Some
aftermarket or generic replacement parts do not
have the characteristics that will allow them to
operate safely in Hatco equipment.
Use only low pressure halogen light/heat lamps
that meet or exceed National Sanitation
Foundation (NSF) standards and are specifically
designed for food holding areas.
NOTE: Hatco halogen heat lamps meet NSF
standards for food holding and display areas.
For 120V applications use Hatco part
number 02.30.117.00. For 220, 230, and
240V applications use Hatco part number
02.30.126.00.
1. Turn off the unit, unplug the power cord, and
allow the unit to cool.
2. Holding one hand under the lamp cover, use a
screwdriver to remove the two screws that
secure the lamp cover in position.
NOTE: The glass shield inside the lamp cover is
loose and will drop down with the lamp cover.
Make sure to support the lamp cover with
one hand during removal of the screws.
Do not touch the halogen heat lamps with bare
skin. Oils from the skin will cause premature
failure of the lamps.
3. While wearing gloves or using other protection,
remove the old heat lamp from the lamp holder.
The heat lamps are held in position with spring
steel contacts on each side of the lamp holder. To
remove:
a. Grasp the old heat lamp and carefully push it
into one of the spring steel contacts in the
lamp holder to release it from the opposite side
spring steel contact.
b. Pull the free end of the lamp down and remove
the lamp from the lamp holder.
NOTICE
WARNING
4. While wearing gloves or using other protection,
install the new heat lamp into the lamp holder.
a. Grasp the new heat lamp and carefully push
one end into the spring steel contact in one
side of the lamp holder.
b. Lift the other end of the lamp into position
against the spring steel contact on the
opposite side of the lamp holder (opposing
pressure from the spring steel contacts will
hold the lamp securely in the lamp holder).
5. Position the lamp cover with glass shield over the
heat lamp and secure using the two screws.
Figure 15. Replacing a Heat Lamp
Lamp
Cover
Lamp
Lamp
Holder
Screw