Hatco MACHO NACHO FDW-1-MN Series, Инструкция по установке и эксплуатации

Страница: 11 / 16

MAINTENANCE
9 Form No. FDWM-0602
Once the unit has finished draining, the drain assembly
can be removed by pressing the release tab and gently
pulling the fitting out.
The Hatco Flav-R-Fresh Holding and Display Cabinets
are designed for maximum durability and performance,
with minimum maintenance. The rack motor and blower
motor are permanently lubricated and require no
maintenance.
NOTE: If the water used has an excessive amount
of lime or mineral content, follow the instructions for
periodic cleaning and deliming of the water reservoir.
REMOVING LIME & MINERAL
DEPOSITS
1. Turn the power switch off and unplug the unit from
its power source.
2. After the unit has cooled down, drain all remaining
water out of the unit.
3. Fill the unit with a mixture of water and delimer.
NOTE: The delimer used should be a safe, non-toxic,
non-corrosive solution. Follow the delimer’s instructions
for proper mixture of water and delimer solution.
4. Allow the unit to stand with the mixture in the
reservoir for the recommended period of time.
(The time required will vary depending
on the solution used and amount of deposits
in the reservoir.)
5. After the deliming period, drain the solution from
the tank.
6. Continue to fill and drain the unit with water only
until the discharge is clear and all deliming solution
has been removed and rinsed.
7. Plug the cabinet power cord into its power source
and fill the unit as usual for daily operation.
NOTE: How often this procedure must be performed
depends on the lime and mineral content of the water
used for daily operation.
DISPLAY LIGHT BULB REPLACEMENT
The display light is an incandescent bulb which
illuminates the warming area. This bulb has a special
coating to guard against injury and food contamination
in the event of breakage.
To replace a bulb, disconnect the power supply and wait
until the unit has cooled. Display lamps have a threaded
base. Unscrew the bulb from the unit and replace it with
a new specially coated incandescent bulb. Hatco
shatter-resistant bulbs meet N.S.F. standards for food
holding and display areas.
WARNING
Only bulbs which meet or exceed N.S.F. standards,
specifically designed for food holding areas must be
used. Breakage of bulbs not specially coated could
result in personal injury and/or food contamination.
WARNING
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact
the Hatco Service Department at 800-558-0607
or 414-671-6350; fax 800-690-2966 or International
fax 414-671-3976.
WARNING
This product has no “user” serviceable parts.
To avoid damage to the unit or injury to personnel,
use only Authorized Hatco Service Agents
and Genuine Hatco Parts when service is required.
WARNING
Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which they
are used. Some aftermarket or generic
replacement parts do not have the characteristics
that will allow them to operate safely in Hatco
equipment. It is essential to use Hatco Replacement
Parts when repairing Hatco equipment. Failure
to use Hatco Replacement Parts may subject
operators of the equipment to hazardous electrical
voltage, resulting in electrical shock or burn.