Hatco MACHO NACHO FDW-1-MN Series, Инструкция по установке и эксплуатации

Страница: 10 / 16

MAINTENANCE
8
Form No. FDWM-0602
CLEANING
WARNING
To prevent electric shock or injury, turn the power
switch off, unplug the unit from the power source
and allow to cool completely before performing
any maintenance or cleaning.
WARNING
To prevent any injury discontinue use if power cord
is frayed or worn.
Hatco Flav-R-Fresh cabinets are made of stainless steel
and aluminum. To preserve the bright finish,
it is recommended that the exterior and interior surfaces
be wiped daily with a damp cloth. Food pans should
be removed and washed. Stubborn stains may
be removed with a good stainless steel cleaner
or a non-abrasive cleaner.
CAUTION
Use only non-abrasive cleaners. Abrasive cleaners
could scratch the finish of your Flav-R-Fresh
Holding and Display Cabinet marring its appearance
and making it susceptible to soil accumulation.
Clean the glass sides using a common glass cleaner. For
hard-to-clean stains, removal of the glass is suggested.
To Remove The Glass:
1. Lift the glass to be cleaned from the bottom
of the cabinet.
2. Pull the lower edge away from the cabinet.
3. Carefully lower the glass until the top clears
the cabinet.
To Replace The Glass:
1. Position the glass with the top edge under
the cabinet lip and raise the glass until it clears
the bottom channel of the cabinet.
2. Move the bottom of the glass towards the cabinet
until the glass rests against the cabinet frame.
3. Carefully lower the glass until it rests in the bottom
channel of the cabinet.
To Remove The Rotating Rack For Cleaning
(Models FDW-1 and FDW-2):
1. Open the front access door.
2. Remove the two (2) pins from the rotating rack
coupling located at the top of the rack inside
the cabinet. See Figure 8.
Figure 8. Removing Motorized Display Racks
3. Lower the connecting coupling until it is free of the
motor shaft and remove the rack from the cabinet.
To Replace The Rotating Rack:
1. Insert the rack into the cabinet through the access
door and place and rack bottom point in the dimple
located at the center of the cabinet floor.
2. Slide the rack coupling up onto the motor shaft and
align the coupling holes.
3. Insert the two (2) pins through the coupling and
through the shafts.
DRAINING THE RESERVOIR
WARNING
To avoid any injury, turn the power off to the unit
and allow to cool before draining.
It is recommended that the Flav-R-Fresh water
reservoir be drained prior to moving the cabinet
and after removing lime or mineral deposits from
the water reservoir.
NOTE: The drain hose assembly is located inside
the cabinet at the right front corner.
To drain the reservoir insert the drain fitting with hose
into the water outlet, located on the ceiling of the
cabinet. Once the fitting is installed, water will begin
to drain from the hose.
NOTE: Position a container to hold the water
while draining.