INSTALLATION
6
Form No. HBGM-0608
General
Use the following procedures to install the HBG and
HBGB units.
ELECTRIC SHOCK HAZARD: Do not attempt to
repair or replace a damaged power cord. The
cord must be replaced by Hatco, an Authorized
Hatco Service Agent, or a person with similar
qualifications.
FIRE HAZARD: Locate the unit a minimum of 1″
(25 mm) from combustible walls and materials. If
safe distances are not maintained, combustion
or discoloration could occur.
Locate the unit at the proper counter height in
an area that is convenient for use. The location
should be level to prevent the unit or its
contents from falling accidentally and strong
enough to support the weight of the unit and
contents.
Do not lay unit on the side with the control panel
or damage to the unit could occur.
HBG Models
1. Remove unit from box.
2. Remove the information packet.
NOTE: To prevent delay in obtaining warranty
coverage, fill out and mail in the warranty
card to Hatco.
3. Remove tape and protective packaging from all
surfaces of unit.
4. Place the unit in the desired location. Make sure
all the feet on the bottom of the unit are
positioned securely on the countertop.
ELECTRIC
SHOCK
HAZARD:
Unit
is
not
weatherproof. Locate the unit indoors where the
ambient air temperature is a minimum of 70°F
(21°C).
HBGB Models
Do not operate built-in models without the
control box mounted properly as described in
the installation instructions.
CAUTION
WARNING
NOTICE
CAUTION
WARNING
This unit is recommended for use in metallic
countertops. Damage to non-metallic countertop
material caused by heat generated from Hatco
equipment is not covered under the Hatco
warranty. For other surfaces, verify that the material
is suitable for temperatures up to 200°F (93°C).
1. Remove unit from box.
2. Remove information packet.
NOTE: To prevent delay in obtaining warranty
coverage, fill out and mail in the warranty
card to Hatco.
3. Remove tape and protective packaging from all
surfaces of unit.
4. Prepare the countertop opening. Refer to the
“Countertop Cutout” chart on the following page
for
recommended
countertop
cutout
dimensions.
5. Apply a bead of NSF-approved sealant on the
top edge of the countertop cutout and the
underside of the trim mounting ring (see
Figure 7). The sealant must be rated for use at
a minimum temperature of 250°F (121°C).
6. Place the unit into the countertop opening.
7. Remove any excess sealant.
8. Locate the remote control box assembly in an
area that is convenient for operation. If
necessary, remove the end brackets from the
control box, rotate, and reposition them. The
control box will require a hole mounting pattern
of 7-5/8″ x 1-1/4″ (194 mm x 32 mm). See
Figure 8 for mounting distances.
NOTE: The remote control box should be mounted
using screws with a 1/4″ (6 mm) minimum
diameter screw head inserted through the
keyholes located on the mounting brackets.
The remote control box is to be readily
removable, not permanently mounted.
Do not modify wiring or cut thermostat capillary
wire on control box to increase semi-remote
mounting distance. Cutting the thermostat
capillary wire will cause the unit to overheat and
may damage the unit as well as the surrounding
countertop.
9. Once all components are secured, proceed to
the OPERATION section.
NOTE: A 6′ (1829 mm) cord is supplied with this
appliance; any excess cord should be
neatly routed so it does not hang down.
NOTICE
NOTICE
All manuals and user guides at all-guides.com
