Form No. GR3SDSCTm-0614
7
OPERATION
English
General
Glo-Ray Heated Glass merchandisers are designed for ease
of operation. Perform the following procedure to operate the
unit.
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
Do not place food product directly onto hardcoat surface.
Food product must be wrapped, boxed, or on a food pan.
Do not allow the glass shelf to overheat. Overheating may
cause the food containers to melt or soften.
Do not use food pans, ceramic dishes, or abrasive
materials on heated glass shelf. Scratching of the glass
surface may occur, marring its appearance and making it
susceptible to soil accumulation. Damage to glass surface
or breakage of glass caused by misuse is not covered
under warranty.
Startup
1. Plug each power cord on the unit into a properly grounded
electrical receptacle of the correct voltage, size, and plug
configuration. See the SPECIFICaTIONS section for
details.
2. move the LIGHTS ON/OFF (I/O) switch to the ON (I)
position. The fluorescent lights will illuminate.
NOTE: The Glo-Ray Heated Glass Merchandiser can be used
with the lights on or off.
WARNING
NOTICE
BURN HAzARD:
• Some exterior surfaces on unit will get hot. Use caution
when touching these areas.
• Do not come in contact with heated glass shelf during
operation. Both sides of heated glass shelf are very hot.
3. move the POWER ON/OFF (I/O) switches to the ON (I)
position.
• The heated base, glass shelf/shelves, and canopy heat
will energize.
4. Turn the HEaT CONTROL knobs to the desired settings.
NOTE: It is not necessary to operate the unit with all the heated
shelves and the heated canopy on. Turn on only the
desired heat sources.
NOTE: All heated glass shelves and the canopy element have
a maximum operating temperature of 200°F (93°C).
5. allow the unit 15–20 minutes to reach operating
temperature before loading preheated food product.
Shutdown
1. move all POWER switches to the OFF position. all lights
and heat sources will shut off.
2. allow the unit to cool, and perform the “Cleaning”
procedure in the maINTENaNCE section.
CAUTION
BASE HEAT CONTROL Knob
POWER ON/OFF (I/O) Switches
HEAT CONTROL Knobs
LIGHTS ON/OFF (I/O) Switch
BASE HEAT CONTROL Knob
LIGHTS ON/OFF
(I/O) Switch
POWER ON/OFF (I/O) Switches
HEAT CONTROL
Knobs
GR3SDS-39DCT Control Panel
GR3SDS-39TCT Control Panel
