Form No. FSHC7WM-0121
14
English
OPTIONS AND ACCESSORIES
Installing Legs
Use the following procedure to install optional 4″ (102 mm) or
6″ (152 mm) legs.
1. Remove the pan slides and reservoir cover from inside the
cabinet and drain the water reservoir, if necessary.
2. Carefully lay the unit on its back side. This step requires
two people.
NOTE: Place a piece of cardboard between the cabinet and
the floor to prevent marring the cabinet finish.
3. Remove the mounting screws and casters on each corner
of the unit, if installed.
4. Reinstall the two inside mounting screws at each corner
directly into the bottom of the unit. They are not needed for
leg installation.
5. Using the remaining two mounting screws from each
caster, install the two leg assemblies to the bottom of the
unit. Tighten securely.
4″ Leg
Assembly
Unused mounting
screw installed.
Mounting
Screw
6″ Leg Assembly
Installing Legs
6. Return the unit to its upright position. This step requires
two people.
7. Replace the pan slides and reservoir cover inside the
cabinet.
8. Level the unit after it is placed in its final position. The feet
on the legs are adjustable for leveling.
Stacking Option
A stacking option is available for stacking one unit on top
of another. The stacking option requires the purchase of an
additional unit with a stacking bracket and hardware to secure
the top unit to the bottom unit.\
NOTE: Casters are required on stacked units.
1. Make sure the bottom unit is completely assembled with
casters installed. Refer to the appropriate procedure in
either the INSTALLATION section or the OPTIONS AND
ACCESSORIES section.
2. Remove the pan slides and reservoir cover from inside
each cabinet and drain the water reservoirs, if necessary.
3. Carefully lay the top unit on its side (this step requires at
least two people).
NOTE: Place a piece of cardboard between the cabinet and
the floor to prevent marring the cabinet finish.
4. Attach the stacking bracket to the underside of the top unit.
a. Position the bracket so that the flange without screw
holes is toward the front and the flange with two screw
holes is toward the back.
b. At each corner of the bracket, thread a bracket screw
through the small hole on the bracket and into the
underside of the unit (four screws total, supplied with
kit). Tighten securely.
5. Remove and discard the following screws from the top
cover of the bottom unit:
• One screw on each side
• Two screws on the back
6. Carefully lift and place the top unit onto the bottom unit
(this step requires at least two people). The flanges on the
stacking bracket will fit around the front, sides, and back of
the bottom unit.
CAUTION! Do not lift unit by stacking
bracket. Bracket has edges that may cause injury.
7. Align the holes in the side and back flanges of the stacking
bracket with the holes in the sides and back of the top
cover on the bottom unit.
8. Install the four mounting screws (supplied with kit) through
the holes in the sides and back flanges of the stacking
bracket and into the holes in the sides and back of the top
cover on the bottom unit. Tighten securely.
9. Replace the pan slides and reservoir cover inside each
cabinet.
Mounting
Screw
Stacking
Bracket
Top
Cover
Bracket
Screw
Stacking two units (FSHC-7W1-EE shown)
