MAINTENANCE LIST
12.
MAINTENANCE LIST
Your careful and routine maintenance of equipment including lubrication and cleaning is essential for long and
problem-free operation
Check point
Check method
Measure
daily weekly monthly
Sweat, dust and oil on
surface
Inspection with unaided
eye (window, control board,
handgrip, foot rail, motor cover)
1.Cleaning with dried cloth
2.Cleaning with wet cloth
O
Sweat, dust and oil inside
of treadmill
Inspection with unaided eye (drive
section inside of motor cover)
1.Switch off
2.Remove dust and foreign materials by
vacuum cleaner (especially dust on inverter
fan)
O
Power cord
Inspection with unaided eye
(plug, cable condition, socket)
1.Cable defective : replace power cable
2.plug, socket to be tighten
O
Tension and side- draft of
belt
Inspection with unaided eye
(Tension and side-draft of running
belt)
1.Drive at 10Km
2.Adjust with T-wrench (refer to installation
and assembly in manual)
O
Level check
Shaking by hand ( level status of
treadmill )
Adjust level foot bolt by a spanner
(up/down)
O
POLY V-Belt
Tension of POLY V-Belt (by
pushing down)
Adjust motor tension bolt
O
Foreign substances inside of
V-belt (including oil/)
Remove foreign substances or call for
customer service
Lubrication
(normal deck)
Friction between deck and belt and
surface status under belt
1.Drive at 4Km
2.Inject oil on deck (refer to oil injection)
O
Lubrication
(SUS deck)
O
Lubrication on incline
motor (for incline model)
Lubrication status of incline gear
(screw)
1.Set treadmill at 16% incline
2.Put grease on incline gear
O
CAUTION : Please turn off power when inspecting. If user needs to turn off and on treadmill, please wait until beep sound stops.
And then, turn on treadmill. It is to avoid any damage to PCB from remaining current.
B-7. TROUBLE-SHOOTING
13.
TROUBLE-SHOOTING
If one of the following messages is displayed on the MESSAGE window while using the machine, take corrective action as
described below
Message
Description
Probable Cause
Corrective Action
SE-1
Mal-function during operation
Mainly caused by the
communication error or the ESD
Check the cable and treadmill
surroundings.
UE-2
Input power under voltage
Mainly caused by an improper power
inlet connection
Check the input power voltage and
connection
OE-3
Input power under voltage
Check the input voltage
OH-4
Inverter/motor over temperature
error
Mainly caused by the cooling
fan failure
Clean the fan blades or replace
the
fan unit
OC-5
Inverter over current error
Caused by an impulse load
current
Check the running belt
lubrication
RESTART
Inverter and console initialization
error
Mainly caused by the
communication
error
Check the cable between the
inverter and the console
21
