Haskris OPC 12, Инструкция по эксплуатации

Страница: 9 / 37

6 | P a g e
2.0 INSTALLATION
2.3 Unit Dimensions
OPC 12
, 38.25”W x 38.25”D x 73.75”H
(97.16cm W x 97.16cm D x 187.32cm H)
Note: Add 4” (10.2cm) to W & D for flange
dimensions.
2.4 Electrical Power
The nameplate can be found on the
Haskris system, located near the units
supply and return connections. The wiring
diagram for your Haskris system is inside a
plastic envelope, attached to the inside of
the system (usually on the Electrical box).
NOTE:
We recommend contacting a
licensed electrician to perform the
electrical installation. These
Professionals are familiar with
local electrical codes and will be
aware of specific requirements
that apply to your area.
We recommend a service disconnect
switch and time delay fusing be installed,
per the wiring diagram, found inside your
Haskris Chiller. Your system will either use
single-phase power or three-phase power.
Do not mount or support any electrical
service disconnect directly to the chiller.
REAR VIEW
NOTE:
Crankcase Heater
– Leave
disconnect ON (energized)
overnight prior to system start up.
This energizes the crankcase
heater and drives out any
accumulated liquid refrigerant in
the compressor.
Use flexible
conduit from
service panel
disconnect thru
pilot hole to main
electrical panel.
Do Not Use rigid
conduit at
chiller.