HASE COMO B.20, Руководство по эксплуатации

Страница: 36 / 74

36
8. Adding Fuel / Heating at Nominal
Thermal Output
More fuel should be added to the fire when the
flames from the previous burning off phase have just
gone out.
Adding Fuel / Heating at Nominal Output
Procedure Position of
Control Elements
Close fire grate. Push in fire grate slider.
Add two logs weighing
approx. 1.5 kg total, place
them with the ends facing
the front of fire box. Only
add one layer of fuel.
Adjust combustion air. For
better ignition, pull out the
air slide until it reaches
the red mark (approx.
1min) until the logs are
completely ignited.
Then set the air slide to
position 2.
Tab. 2
CAUTION!
Please ensure that the logs are inserted
with sufficient distance (at least 5 cm)
from the furnace window.
9. Heating at Low Thermal Output
(during Transitional Seasons)
You can vary the thermal output of your Como by
adjusting the quantity of fuel used.
NOTE!
Do not attempt to slow down the com -
bustion by reducing the air supply. When
heating with wood, this can result in an
incomplete burning process and pose the
risk of an explosive like combustion of the
accumulated wood gases (deflagration).
During the transition seasons (spring/au -
tumn), outdoor temperatures in excess of
16° can cause disruptions to the airflow
in the chimney. If at this temperature a
draught cannot be created by burning a
piece of paper or a small piece of wood (a
pilot fire), no fire should be lit.
10. Emptying the Ash Drawer
As a safety precaution, please make sure that you
only dispose of ashes once they are cold.
The ash drawer contains the mineral components of
the wood (approx. 1%) as combustion residues.
Remove the ash drawer. Make sure the ash does
not pile up all the way to the bottom of the fire box.