Step 22 - Fit the doors
Parts
2 x polycarbonate door
With handles fitted
Pop the doors into the sliding channels by flexing them slightly.
The le hand door goes in the rear (inside) channel and the right
hand door goes in the front (outside) channel. Refer to the door
drawing at the beginning of the guide.
Tip:
If the doors are too tight, you can loosen the crossbar mounting bolts to let the bar come up
a little. Tighten them in a suitable position so that the doors slide well.
Step 23 - Fit the hole caps
Weʼve supplied some small black plastic caps to cover the screw holes in the front of the
greenhouse to make it look smarter.
Nowʼs the time to fit the caps, sit back and have a cup of tea.
Step 24 - Secure the greenhouse down
If you are in an exposed location, we recommend that you secure the greenhouse to the ground,
a wall or a fence.
Parts
2 x Angle bracket
2 x Square nut
2 x M5 x 8mm bolt
Use the spare square nuts in the rear upright side slots, with an M5 x
8mm bolt and the stainless steel angle bracket (or a bracket of your
choice to suit what youʼre mounting to)
