Step 15 - Lid side bars
This is easiest done on a flat table or worktop.
Parts
1 x lid rear
2 x square nut
2 x M5 x 10mm
2 x lid sidebar 45cm with corner cubes
1 x o-ring
Le and Right lid sides will be marked with the corner cubes facing towards you, as per the
drawing above.
1. Slide two square nuts into the outside channel of the right lid sidebar. These will form
the top bolts for the storm lock as per drawing below.
2. Screw the 10mm bolts into the nuts and tighten them by hand to lock them in place.
3. Fit the o-ring over the two bolts on the side of the lid. This is what the lock will look like
when in operation, holding the lid down:
1. Slide the lid sides into the ends of the lid rear, with the closed side upwards.
2. Tighten the screws.
Step 16 - Insert the lid polycarbonate
Parts
1 x clear lid panel
Slot in the lid polycarbonate sheet, with the holes at the front.
Make sure the white UV protected side is upwards.
Youʼll need to flex the lid side bars apart slightly.
