H13XT
Assembly
Manual
Page
9
of
33
Step 10
Next, slide the 4 bolt 1-3/4” cast flange bearing over the shaft making sure the grease zerk is located on the
same side as top bearing. (If the shaft has surface rust, clean first with an emry cloth) Secure the 4 bolt bearing
to the infeed housing using (4) 1/2" x 1-1/2” carriage bolts & flange nuts as shown. When completed use a
punch to rotate the shaft so the keyway is in an easy to access position.
Step 11
Next, insert 1/4" x 1” square key into the top shaft & 3/8” x 1-1/2 “ key into the bottom shaft. Slide the 18 tooth
sprocket onto the top shaft & the 20 tooth sprocket onto the bottom shaft as shown in fig. 11.1. Use a
measuring tape & measure the distance from the center of each sprocket to the infeed housing. Once sprockets
are aligned, apply lock-tite to set screws & tighten.
Fig. 10.1
Fig. 11.1
