6
Installation of Mounting Brackets, Tank, and Drain / Fill Line (continued)
If your baler has a sidewind jack, complete the next steps. If your baler does not have a sidewind jack, skip to
the tank installation on page 7.
Locate the jack bracket assembly (001-4704KM) and fasten it to the existing jack mounted on the baler shown
at point G in figure 7 using two
1/2” x 4½” bolts, flats, locks, and nuts. Locate the support bracket (001-
4704KG) and fasten it to the top hole on the jack bracket assembly (001-4704KM) shown at point H in figure 8
using a ½” x 1½” bolt, flat, lock and nut. You may have to cut off the end of the support bracket (001-4704KG)
at the notch to fit the baler.
Locate the support bracket (001-4704KG) and fasten it to the inside of the U-Bracket (001-4704KB) shown at
point I in Figure 9 below using two 3/8” x 1¼” bolts, flats, locks, and nuts.
001-4704KG
001-4704KB
001-4704KJ
Figure 9
I
001-4704KG
H
001-4704KM
Figure 7
001-4704KM
G
Figure 8
001-4704KM
