5
Installation of Mounting Brackets, Tank, and Drain / Fill Line (continued)
Locate the tank saddle U-bracket (001-4704KB) and line it up over the baler tongue so it matches up with the
tank saddle legs (001-4704KE & 001-4704KF) at point C and D as shown in figure 3. Fasten 001-4704KB to
the left saddle leg (001-4704KE) at point C
using two 1/2” x 2” bolts, flats, locks, and nuts. Do the same with
001-4704KB to the right saddle leg (001-4704KF) at point D
using two 1/2” x 2” bolts, flats, locks, and nuts.
Locate the tank bracket (001-4704KA) as shown in figure 5. Fasten 001-4704KA to the tank saddle U-Bracket
(001-4704KB)
with four 1/2” x 1 ½ ” bolts, locks, flats, and nuts at the four corners at the bottom of 001-4704KA
as shown at point E. Tank may need to be removed from the tank bracket (001-4704KA) to do this. The bolt
heads and flat washers should be on the top. Locate the toolbox bracket (001-4704KJ) as shown in figure 6.
Fasten 001-4704KJ to 001-4704KB
with four 3/8” x 1 1/4” bolts, locks, flats, and nuts as shown at point F.
001-4704KE
001-4704KF
Figure 3
D
C
001-4704KB
001-4704KA
001-4704KJ
001-4704KB
Figure 5
Figure 6
001-4704KB
E
F
B
B
D
B
Figure 4
