Hartmann Tensoval Mobil, Инструкция по эксплуатации

Страница: 15 / 149

sured values are in memory, the
mean value will be calculated from
these two measured values. If only
one measured value is in memory,
no mean value will be calculated.
You can cancel the memory’s recall
of data at any time by pressing the
START/STOP button. Otherwise the
device will switch itself off auto-
matically after approx. 30 seconds.
Even if the power supply fails, e.g.
when changing the batteries, the
stored values will still be available.
5.3 Deleting the measured
values
You can delete all stored data
either in M1 or in M2. To do this,
press the memory button of the
corresponding memories M1 or M2.
The average value will appear on
the display. Hold down the memory
button for a longer time. After four
seconds the display will flash and
after further four seconds all data
will be deleted. On the display
appears only M1 or M2.
Important: If you release the
memory button before the end
of the time limit, no data will be
deleted. If there is only a single
English
When pressing again, the most
recently stored measured value will
be displayed. By repeatedly press-
ing the memory button all stored
values of the selected memory can
be recalled one by one. The mea-
sured value and the number of the
memory position are displayed
when you access stored values. The
number of the memory position,
the date and time appear in 2 – 3
second intervals.
Tensoval mobil can store up to 60
measured values for each person
(M1 or M2). The most recent meas-
ured value is always in memory
position No.1. When all memory
positions are occupied the oldest
value will be deleted each time.
Important: The calculated
mean value is based on all
measured values stored for the
respective person. If only two mea-
17