HART HGHST01, Руководство оператора

Страница: 13 / 40

9 – English
OPERATION
WARNING:
Make sure the latch on the battery pack snaps in place
and the battery pack is fully seated and secure in the
trimmer battery port before beginning operation. Failure
to securely seat the battery pack could cause the battery
pack to fall out, resulting in serious personal injury.
INSTALLING/REMOVING THE BATTERY PACK
See Figure 5.


Slide power selection door over power receptacle until
it clicks into place.
  Insert the battery pack into the product as shown.


Make sure the latch on the battery pack snaps into
place and the battery pack is secured before beginning
operation.
  Depress the latch and pull to remove the battery pack.
For complete charging instructions, see the operator’s
manuals for your battery pack and charger.
STARTING/STOPPING THE TRIMMER (DC)
See Figures 5 - 6.
To start:


Slide power selection door over power receptacle until
it clicks into place.
  Insert battery.


Press and hold the lock-out.


Depress the switch trigger.
To stop:


Release the switch trigger to stop the motor.


Upon release of the switch trigger, the lock-out will
automatically reset to the locked position.
STARTING/STOPPING THE TRIMMER (AC)
See Figures 6 - 8.
To start:


Remove battery pack from trimmer if installed.


Slide power selection door over battery port until it clicks
into place.


Route an extension cord loop through the opening behind
the rear handle and wrap around the cord retainer.
NOTICE:
Always use cord retainer to properly attach extension
cord to string trimmer. Failure to use cord retainer may
result in damage to string trimmer and/or extension cord.


Attach the outlet end of the extension cord to the plug
on the rear of the string trimmer.
NOTE:
Use only approved outdoor extension cords.
  Press and hold the lock-out.


Depress the switch trigger.
To stop:


Release the switch trigger to stop the motor.
  Upon release of the switch trigger, the lock-out will
automatically reset to the locked position.
TELESCOPING SHAFT
See Figure 9.
The shaft can be extended or shortened for ease of use.
  Remove the battery pack or disconnect from power
supply.


Loosen the telescoping shaft coupler by turning it coun-
terclockwise. Slide the shaft to the desired position.
  Tighten the coupler by turning clockwise. Make sure the
shaft is securely tightened before reinstalling the battery
pack or reconnecting to the power source.
OPERATING THE TRIMMER
See Figure 10.


Hold the trimmer with your right hand on the rear handle
and your left hand on the front handle.


Keep a firm grip with both hands while in operation.


Trimmer should be held at a comfortable position with
the rear handle about hip height.
  Cut tall grass from the top down. This will prevent grass
from wrapping around the boom housing and string head
which may cause damage from overheating.
If grass becomes wrapped around the string head:
  Remove the battery pack or disconnect from power
supply.


Remove the grass.
WARNING:
Always hold the string trimmer away from the body
keeping clearance between the body and the string
trimmer. Any contact with the string trimmer cutting head
while operating can result in serious personal injury.
CUTTING TIPS
See Figure 11.


Keep the trimmer tilted toward the area being cut; this
is the best cutting area.


The string trimmer cuts when passing the unit from right
to left. This will avoid throwing debris at the operator.
Avoid cutting in the dangerous area shown in figure 11.


Use the tip of the line to do the cutting; do not force string
head into uncut grass.