Product:
Code:
SHE-011/016/021/026/031/036/041/046
Premier
Curved Team Shelter
Socketed
Page 5
7
.) Once all the plastic is in place the
crossbar (6) needs to be fixed into
position. Attach the crossbar using the self
tapping screws (25), locate the holes in the
crossbar and line the holes up with the
screw port in the bent supports. It is best
to fix in the end screws first so that the
crossbar is supported at either side. You
then need to tighten up the middle 3
screws gradually as the crossbar pulls
onto the face of the bent supports.
. When doing so make sure the
plastic sheets are lined up to fit into the
recess of the crossbar. This is important as
this will hinder the screws from pulling into
the supports.
You will
need a 10mm deep drive socket/FAS005
(30) for this
When the crossbar is fitted tightly you can finish it off by inserting
the round caps (26) into the front of the crossbar and the end
caps (27) in either end of the crossbar by using the 10g self
tapping screws (
) (Figure 12).
29
Figure 10
6
.) At this point the back sheets (9) need to be slid
into place. Again this is a 3 person task, one person
will need to hold and support the weight of the sheet
and the other 2 to guide and push the sheet into the
recess into position. The sheets need to slide into the
recess of the extrusion of the bent supports, where
the rubber is located (shown more clearly in figure
11).
.
The sheet must slide in square, otherwise it will grip
on the rubber and wont slide in. As the plastic sheet
nears the bottom, make sure you line it up with the
back support slot so when it reaches the bottom it will
locate in position.
Note: It is recommended to use some kind of
silicone lubricant to aid the plastic sheets to slide in
Note: There will be an overhang of approx 13mm at the
top of the support.
9
26
25
27
6
Figure 12
29
Figure 11
9
3
