Code
Product
HOC-240
Freestanding Hockey 5s Surround
Page 3
3
Drill two 8.5mm holes in the outside wall of the uprights to the dimensions shown and tap
both M10x1.5. Bolt Rebound Board to upright using two M10x20mm Set Screws and two
M10 washers.
(not supplied)
m
m
55mm
25mm
225mm
M10
x2 Holes Ø8.5mm
then tap M10
Front face
of upright
1
M10x20mm
Set Screw
M10
Washer
a
4mm
3
Sandwich the side of a Rebound Board between the Goal and Goal Bracket. Ensure the
Rebound Board used on the left hand side of the goal does not have a Joining Plate
attached. Ensure the board foam is flush with the front of the Goal upright and tighten the Button
Screws and joint connector nuts.
7
8
4
1
8
IMPORTANT:
Step 3a refers to installation with goals other than
Harrod UK Ltd models HOC-150 to HOC-170. Please ignore this
step if you are using one of the above models.
i
