HARRISTON INDUSTRIES 93066, Руководство оператора

Страница: 63 / 92

58
5 SERVICE AND MAINTENANCE
1. Follow all the operating, maintenance, and
safety information in the manual.
2. Support the machine with blocks or safety
stands when changing tires or working
beneath it.
3. Stop tractor engine, lower machine to the
ground, place all controls in neutral, set park
brake, remove ignition key, and wait for all
moving parts to stop before servicing,
adjusting, repairing, unplugging, or filling.
4. Make sure all guards are in place and
properly secured when maintenance work is
completed.
5. Never wear ill-fitting, baggy, or frayed
clothing when working around or on any of
the drive system components.
6. Before applying pressure to a hydraulic
system, make sure all lines, fittings, and
couplers are tight and in good condition.
7. Install safety rod and pin securely in
position on hitch cylinder frame before
working under frame. Make sure safety rod
is unhooked before resuming operation.
8. Relieve pressure from hydraulic circuit
before servicing or disconnecting from
tractor.
9. Keep hands, feet, hair, and clothing away
from moving or rotating parts.
10. Clear the area of bystanders, especially
small children, when carrying out any
maintenance and repairs or making any
adjustments.
11. Wear appropriate protective gear when
contacting chemical handling components
on machine.
5.1 Service
5.1.1 FLUIDS AND LUBRICANTS
Grease
Use an SAE multi-purpose high temperature
grease for all applications Also acceptable is
an SAE multi-purpose lithium based grease.
Roller Chain Lubricant
Use WD-40, LPS-2, or equivalent to coat
roller chains and bushings to prevent rusting
or seizing.
Storing Lubricants
Your machine can operate at top efficiency
only if clean lubricants are used. Use clean
containers to handle all lubricants. Store
them in an area protected from dust,
moisture, and other contaminants.
When pressure washing, do not directly
spray the side (seal) of the bearing. This
will damage the seal and reduce the life of
the bearing.
5.1.2 GREASING
Use the Maintenance Checklist provided to keep
a record of all scheduled maintenance.
1. Use only a hand-held grease gun for all
greasing. Air powered greasing systems can
damage the seals on bearings and lead to
early bearing failure.
IMPORTANT
Over-greasing can damage bearing seals. A
damaged seal will lead to early bearing failure.
Replace all bearings with damaged seals
immediately.
2. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
3. Replace and repair broken fittings
immediately.
4. If a fitting will not take grease, remove and
clean thoroughly. Also clean lubricant
passageway. Replace fitting if necessary.