Harrison Hydra-Gen HU507-GB12, Руководство по установке и обслуживанию

Страница: 8 / 9

8
Figure 5
STEP 6
1. Grease female splines in Hydra-drive using the remaining Chelsea spline grease. Make
sure to coat all the roots and valleys of the splines.
2. Replace the #8 run tee on the pump pressure port and replace it with a #8 branch tee
supplied with the kit.
3. Remove the bolt from the port cap of the pump as shown in figure 6. This will be used to
add the rear support bracket.
4. Install the SAE-B gasket # DQ712X256 to the pump pilot.
5. Install the pump to the Hydra-drive. Using the two 1/2" flat washers #DF990-0500 and
the two hex head bolts #DF990-0513 (top bolt) and the #DF990-0527 (bottom bolt).
6. Torque the bolts to 55 ft. lbs.
7. Remove the 2 oil pan bolts needed to mount the rear support bracket.
8. Install the mounting bracket to the pump using the bolt DF990-4320 (7/16-14X2.0 SHCS)
hand tighten.
9. Install the 2 spacers MC507-9251 using the 2 bolts DF990-6025M to the transmission oil
pan.
10. Tighten the 7/16 bolt to 55 ft. lbs. and the 6mm bolts to 8 ft. lbs.
11. Install the suction and pressure hose to the pump.
12. Remove the case fitting and fill the pump case with oil.
13. Replace the case fitting and install the case drain hose.
14. Re-install drive shaft.