Harrison Hydra-Gen HU507-GB12, Руководство по установке и обслуживанию

Страница: 7 / 9

7
STEP 4
1.
The hydra-drive is shipped with 12 ounces of gear oil. GB220-SHCG. The oil is a Mobil
SCH220.
NO NOT USE ANY OTHER OIL.
2.
On the rear housing, there is a 3/8 NPT plug. See figure 4 below. Remove the plug
and fill the gearbox up to the point it starts to come out of the fill hole. Using a clean
oil can with a flexible nozzle is the easiest way to fill the gearbox.
3.
Replace and tighten plug. Clean area of any oil.
4.
Before installing the pump, run the PTO and Hydra-drive. Check for leaks.
Figure 4
STEP 5
1.
Before installing the pump to the Hydra-Drive swap the case fitting from the
back to the side of the pump. See figure 5.
2.
Remove the #8 SAE plug from the side of the pump and install the AQ262-
0808 fitting.
3. Remove #8 long fitting from the rear of the pump and install the #8 SAE plug.