Harris Legacy 99-1300-0, Руководство по эксплуатации и техническому обслуживанию

Страница: 20 / 98

Revision B • 1/03
H A R R I S C O R P O R A T I O N
2-8
2 Installation
Logic control cables are fabricated in a similar
manner to the audio wiring. Strip the jacket insu-
lation back 1½" [38.10 mm], sleeve the cut end
with 3/4" [19.05 mm] of shrink tubing and strip
the insulation from each wire 9/64" [3.57 mm].
CRIMP TOOL OPERATION
A ratcheting AMP MOD IV crimp tool is
included in the tool kit. The tool crimps both the
insulation and wire barrels on the AMP MOD IV
receptacle contacts in one crimping action.
To use the ratcheting crimp tool:
1 Hold the crimp tool with the printed side up.
Insert the contact from the opposite side, with
the barrel openings up, until the insulation
barrel end is flush to the opening of the die.
Close the tool only until the anvil holds the
contact in place (Refer to the cutaway view
on this page).
2 Insert the stripped wire into the contact until
it hits the tool’s wire stop. Hold the wire in
place while squeezing the tool handles to
crimp the contact onto the wire. The tool
handles automatically release and spring open
after the crimp cycle is complete.
Once the contact has been crimped, insert and
lock the contact receptacle into the appropriate
connector housing following the pin-out diagrams
found in the Quick Guides on pages 2-16 to 2-49.
A receptacle contact is inserted into the hous-
ing with its locking tab side toward the locking
tab slots on the side of the connector housing. A
slight click can be heard when the contact’s lock-
ing tab springs up into the locking tab slot.
To remove a contact from a housing, the PRE70-
129 Contact Removal Tool (included in the PRE
76-2001 tool kit) is required. Insert the tool’s tip
into the locking tab slot and press the locking tab
down while lightly pulling on the wire to remove
the contact from the housing.
Crimp Tool — Cutaway View
Anvils
Printed
Side
Wire Stop
AMP MOD IV
Receptacle
Contact
Die
Locking Tab
Locking Tab Slots
Contact Removal Tool
Receptacle Contact
Insertion & Removal Detail
AMP MOD IV
Contact
Crimp Tool
Audio Wire, ready for insertion into an
AMP MOD IV connector housing
AMP MOD IV
Receptacle Contacts
Cable ID
Tag
3/4” [19.05 mm]
Shrink Tubing
Teflon Sleeving
over drain wire