16
DVSD / DVSE6800
+
Installation and Operation Manual
Chapter 3: Operation
Understanding Jumper Controls
Introducing Jumper Control Types
Figure 3-1.
Location of the Jumper Sets and Status Indicators
P1 Jumpers
You can use the P1 jumper set to select the following items:
•
SDO1 and SDO2
•
Loss of signal switch (LOS)
•
Remote control
SDO1 / SDO2
SDO1 and SDO2 allow you to select where to direct output. By using
SDO1 and SDO2, you can configure the module to operate as either
1×8 (SDO1) or dual 1×4 (SDO2). When the shunt is installed on the
jumper the noted output is fed from input 2.
•
When SDO1 is selected, the distribution amplifier functions as a
1×8 with all 8 outputs fed from input 1. LOS enabled will allow
input 2 to serve as a backup to input 1.
•
When SDO2 is selected, the distribution amplifier functions as a
dual 1×4 with each input driving 4 outputs. Input 2 can be used in
conjunction with the LOS enabled to provide a backup input.
Note
Both DVSD6800
+
and
DVSE6800
+
modules use the
P1 jumper set.
