Harris CM-30, Руководство по установке и эксплуатации

Страница: 71 / 157

4 – Configuration & Operation NetXpress LX & CM-30 Installation & Operation Manual
Version 1, September 2010
Harris Corporation 4-25
Intraplex Products
Figure 4-26. Contacts | Configure Output Contact Dialog Box
2. To change the location of the dialog box on your monitor page, click and hold while
dragging the dialog box as desired.
3. Type the output contact’s Remote IP Address .
4. Click Submit to apply changes.
5. Click Close or to exit the dialog box.
4.3.3.3 TDM Bus Information
The TDM Bus Information page (Figure 4-27) shows signaling and time slot activity information for
the NetXpress LX TDM busses and to set the system bus mode, E1 or T1. To access the page, point to
System Cfg and click TDM Bus . Once this page appears, you can also click the edit button to change
loopback/ signaling configuration for each TDM Bus (Figure 4-29).
Figure 4-27. TDM Bus Information
Refresh: Click M to refresh the browser manually, or click 5s , 10s , or 30s to automatically refresh
the browser at 5, 10, or 30 second intervals.
TDM Bus: The specific TDM bus location.
Signaling: Shows the signaling mode for the bus, either None or CAS (channel associated signaling)
in E1 mode or RBS (robbed bit signaling) in T1 mode.