Harrie Leenders CANTA W, Руководство пользователя

Страница: 31 / 50

7
GB
5. Hanging the stove
Place the sliding pieces underneath the MTI brace.
Slide the stove including the MTI brace as close to the wall bracket
as possible. Make sure the oblong holes push aside the eyes.
Attention! Do not damage the floor.
Fix the 2 cotters in the eyes with the opening forwards.
6. Remove the MTI-brace
Remove the 6 bolts out of the MTI-brace (box-spanner s.w. 13).
Remove the MTI-brace.
9. Installing the finishing cover
Install the finishing cover by putting in the cams into the slots.
Use 2 M8 hexagonal screws of the MTI bracket to fix the finishing
cover if too loosely in place.
10. Install the jacket
Remove the packaging from the jacket.
Push the jacket carefully over the stove without damaging the paint.
Position the jacket into a right position (if necessary ) by means of
the 2 m6-bolts on both sides of the stove.
sliding piece
cotter
8. Levelling - 2
Use the 2 M8 bolts at the back from the wall brace to spirit level (A)
the stove ‘in the depth’. (hexagonal 4)
Fasten the 2 cotters.
M-10 bolt
Finishing cover
M6-bolt
7. Levelling - 1
Use the two M10 bolts provided on the underside of the wall bracket
to level the stove widthwise (A) (open-end wrench, j.w. 17).