Harper MultiLoader, Руководство оператора и каталог запасных частей

Страница: 10 / 32

Multi-Loader
Adjusting the Hose Assist
Properly having the hose assist attached to
the inlet hose will prevent most hose clogs
from happening and maximize the Multi-
Loader’s performance by keeping the hose
straight and perpendicular to the housing.
Adjustments for the hose assist are made
by moving up or down a link at a time on the
chain via the carabiner.
Clogged Hose
Even though an operator has adjusted the
hose assist properly, the hose may still be-
come clogged at some point. To unclog the
hose, begin by straightening the inlet hose
out directly behind where it attaches to the
unit to dislodge the clog. If it still isn’t clear,
turn off the machine and wait for the impeller
to come to a complete stop. Then, remove
the hose from the machine and clear the
debris by hand.
SAFETY WARNING!
The debris may be sharp. Be sure to use
appropriate gloves when clearing debris
from the hose or from the housing/impel-
ler.
The primary types of debris are light lawn de-
bris such as leaves and mulch or light plastic/
paper products.
SAFETY WARNING!
Larger or heavier objects have the ability
to cause damage to the machine and/or to
the operator.
Clogged Housing or Outlet Spout
1. Turn unit off and wait for the impeller to
come to a complete stop.
2. Remove the negative battery cable.
3. Remove the hose and determine where
the clog is located.
4. If the clog is in the housing/impeller, re-
move the clog and reassemble. If not, con-
tinue with 5.
5. If the clog is in the outlet spout, remove
the (8) bolts holding the outlet on and take it
off.
SAFETY WARNING!
The outlet spout is heavy. Do not stand
under the spout while removing it.
6. Remove clog from from spout and reat-
tach with the previously mentioned bolts.
Check to make sure that all that was re-
moved from the machine is reassembled and
tightened before resuming operation.
9. Reconnect the negative battery cable and
resume operation.
Adjusting the Belt Tensioner Handle
As the belt stretches with use and time, the
owner can adjust the height of the belt ten-
sioner handle to increase resistance on the
belt by using the
two bolt system
shown in the
picture to the
right.
8 9