Harper MultiLoader, Руководство оператора и каталог запасных частей

Страница: 8 / 32

Multi-Loader
Safety Guidelines
• Use genuine factory parts or parts
with equivalent characteristics, includ-
ing type, strength, and material. Fail-
ure to do so may result in product mal-
function and possible injury to the op-
erator and/or others.
• If hardware is not secure, or if some of
the hardware is over-tightened, equip-
ment failure may result, posing poss-
ible safety hazards.
• To prevent possible eye injury, always
wear SAFETY GLASSES while oper-
ating equipment.
• Replace locknuts and locking screws if
you can tighten them without feeling
considerable resistance for several
turns before they are completely tight.
Replace them with factory authorized
parts or their equivalent.
Gasoline
SAFETY WARNING!
Gasoline is extremely flammable and can
be highly explosive.
• Always use an approved container for
gasoline.
• Do not allow open flames or sparks
while performing maintenance or refu-
eling.
• Never remove the fuel tank cap or add
gasoline when the engine is running or
while it is hot.
• Never fill the fuel tank indoors (fumes
can collect).
• Wipe up spilled gasoline immediately
and completely.
• Do not store gasoline in a room with
an appliance that has a pilot light to
where electrical appliances or switch-
es may cause sparks.
• Always store gasoline outside, in a
safety can (a can which has a flame
arrestor and pressure relief valve in
pour spout).
• Gasoline fumes are heavy and will
sink to the lowest point, collecting and
becoming more and more hazardous.
1 part gasoline in 20 parts air will ex-
plode easily and violently.
• Never store the equipment with gaso-
line in the tank inside a building where
fumes may reach an open flame or
spark. Allow the engine to cool before
storing in any enclosure.
• Be certain to provide adequate ventila-
tion if an engine must be run indoors -
exhaust fumes are dangerous.
Guards & Shields
• Keep all safety devices in place.
• Replace all worn, damaged, unusable,
missing or lost safety shields and
guards before operating the equip-
ment.
• Keep the equipment in good operating
condition.
Safety Decals
• If safety related or instructional decals
become illegible or are removed, re-
place them immediately. New decals
may be obtained from your local Harp-
er Dealer.
• If you replace parts that have such
decals attached to them, make sure
the decals are replaced with current
versions, and are on the replacement
parts before the machine is operated
again.
6 7