- 6 -
V1-02-06
Assembly instructions pivot arm awnings US701 - US702 - US715
Situation 2 – US702
Mark the holes to be drilled on the wall or the fitting surface by using one of the wall
brackets.The outer wall brackets have to be positioned as close as possible to the side
consoles of the box.
Make sure these holes are perfectly in line and use for this purpose waterhose and
plumb line. Do mark, if necessary, the holes for a possible wall bracket to be fitted
into the middle of the box and meant to prevent sagging of the box in the case of
great widths.
Drill the attachment holes into the wall , use a masonry drill Ø12mm.
Introduce the S12 wall plugs into the holes.
Now the wall brackets can be screwed to the wall. If necessary, adjust them to compensate for any
unevenness in the wall. Pull a cord from the two outer consoles in order to control whether the box is
hanging straight. Now tighten the screws firmly.Then lift up the box and attach it to the hooks of the
wall brackets.
In the case of motor operation the motor cable has to be passed through the passage opening before
doing this. Attach the bottom side of the box to the wall brackets, use the screws included (see fig.)
Ensure that the box is perfectly level. Pull a cord from the two outer consoles in order to control
whether the box is hanging straight.
Make sure the holes are dust-free before pushing in the
plugs
