9
With a good calibration of Ph and Rx, the screens disappear automatically. After 2
minutes the screens will disappear and you can read the values from the screen. If
the calibration is correct, the values are as follows:
a.
pH 7.0 +- 0,1
b.
Redox 468 +-10mV
If the values are not within the range as described above, you can press the pH and
Redox keys again to repeat the calibration process.
10
Preparation of the pool water
Make sure that the pH of the pool water is at least between 7.2 and.
8.5 and as close as
possible to 7.4.
Make sure that the chlorstabilisator (cyanic acid) content in the pool water
is between 20-40 ppm (20-40 g / 10 m³)
11 Set parameters
Several parameters need to be set. Press the middle key. You will see the following screen:
11.1))
Language
You can set a (different) language. Press the middle key again. Then navigate
through the upper or lower key to the languages Français, Castellano, Italiano,
English, Deutsch. You confirm your choice of language by pressing the middle key.
11.2) Dosing mode: proportional continuous ( not for salt electrolysis) Salt time, Salt
Rx(for) salt electrolysis
Press the lower key. The setting "dosing method" is now ticked. Press the middle key to
activate this setting. You can now see that the dosing mode Prop (= proportional) or Cont
(continuous) is selected. Press the middle key again. In the salt electrolysis dosing mode
you can choose between Salt time or Salt Rx.
Содержание Hydrolyse EC12
Страница 1: ......
