7
IL500 Sierra Inclined Platform Lift - Installation & Service Manual
TEC0029 2016SEPT12 PN: 630-00001 REV C
Installation Procedures
9. Slide the chassis onto the top of the rail
until
it engages the gear rack. Cut the plastic cable tie
on the mail power breaker (ON/OFF) switch. Turn
the main power breaker on; the lift will emit a
long beep.
Run the lift down near the bottom of the rail
using the install switch (black rocker) on top of
the chassis. When you have the lift in the proper
location turn off the main power breaker.
[Figure 7-1]
10. Install the platform mount onto the chassis
by aligning the two large holes on the end of the
slots with the two large Allen-headed cap bolts
protruding from the side of the chassis. For the
bottom slot, use the one on the downhill side of
the mount.
[Figure 7-2]
Ensure that the bolt heads
are fully seated in the top of the slots, level the
mount and tighten securely. Tighten the two
more cap bolts on the back side of the chassis as
well.
11. Install the Upper Guide Roller
on the back
side of the platform mount. Align the two wheels
with the guide rail and secure with a bolt, nut and
washer through the vertical slot in the platform
mount.
[Figure 7-3]
Route the wire harness from the bottom end of
the chassis, up under the platform mount and up
to the mating connectors. Plug the connectors
into each other.
12. Secure cable with wire ties
through hole in
platform support.
[Figure 7-4]
Figure 7-1
Figure 7-2
Figure 7-3
Figure 7-4
