Harman PF-120, Руководство пользователя

Страница: 14 / 34

Harman® • PF-120 Owner’s Manual_R3 • 2014 -___ • 10/14 14 3-90-08120c
F. Manual Ignition
Lighting the fire manually will not be necessary unless the
igniter system fails.
1. Flip the Igniter Switch Down
into the “MANUAL-LIGHT”
position. See Figure 4.8.
2. Open inner and outer ash doors as shown in Figures
5.1 thru 5.3. Located in the maintenance and service
sections of this manual.
3. Fill burnpot with pellets as shown in Figure 4.9. Only
fill level with the front edge. ( DO NOT OVERFILL )
4. Have matches or other ignition source ready.
5. Turn Mode Selector
to “SERVICE” Figure 4.10.
Figure 4.8
Figure 4.9
Figure 4.10
This will start the combustion blower and allow the ESP to
control the fire in relation to the Temp Dial setting 1 through 7.
Once the fire is well established the Temp Dial can remain on
any number setting desired, or changed to the “AUTOMATIC”
setting. If you change to “AUTOMATIC” remember to set the
Temp Dial to desired temperature.
NOTE:
When the Switch is set to Manual-Light in the
“AUTOMATIC” mode, the wall control will function as in
Auto-Light except the fire will not be allowed to go out. It will
only be allowed to go to a minimum burn rate between the
times the wall control is calling for heat. This rate is about 1
pound of fuel per hour.
7. Light the starting gel with a match.
8. Close the doors
The fire will light and the control will adjust the fire to the
proper level according to the temperature reading at the
wall control.
CAUTION
!
• A vapor flash could occur if too much time is allowed
to pass before lighting the starting gel.
• Care must be taken not to get starting gel on your
hands or clothing. Serious burns could occur during
the lighting process.
• Never try to apply more starting gel to an already
burning fire, or a fire with smoldering pellets.
6. Apply starting gel as shown in Figure 4.11.
NOTE: Stirring the starting gel into the pellets usually
allows the fire to become established quicker.
NEVER USE GASOLINE, GASOLINE-TYPE LANTERN
FUEL, KEROSENE, CHARCOAL LIGHTER FLUID, OR
SIMILAR LIQUIDS TO START OR “FRESHEN UP” A
FIRE IN THIS FURNACE. KEEP ALL SUCH LIQUIDS
wELL AwAY FROM THE FURNACE wHILE IN USE
WARNING
!
STARTER
GEL
Figure 4.11