Harman Martin MAC Aura PXL, Руководство пользователя

Страница: 11 / 46

Control options
11
Control options
You can control the MAC Aura PXL using DMX and/or Martin P3 protocol. The fixture auto-senses the type
of data that it is receiving and will respond correctly with no need for manual protocol selection.
The following options are available:
• DMX control over standard DMX cable connected to the fixture’s 5-pin XLR connectors.
• DMX control using Art-Net over Ethernet cable connected to the fixture’s etherCON connectors.
• DMX control using streaming ACN over Ethernet cable connected to the fixture’s etherCON connectors.
• DMX control over DMX cable and P3 video data over Ethernet cable.
• P3 video data with embedded DMX commands over Ethernet cable. If you connect DMX / Art-Net / sACN
to the P3 system controller, the controller can merge the DMX commands into the P3 signal and send
them to the fixture over Ethernet.
You can decide how the fixture should behave if it receives both DMX data and P3 video data. The default
setting is for DMX data to take priority, but you can set the fixture to give priority to P3 pixels and you can
crossfade between DMX colors and P3 pixels.
Fail-safe connection
The MAC Aura PXL has a fail-safe network connection. If the fixture loses power or if you shut it down, it will
continue to relay an Ethernet signal, and the Art-Net / sACN / P3 signal to the other networked fixtures in the
daisy chain will not be interrupted.
Data rate
Any Ethernet switch used to relay Art-Net, streaming ACN or P3 data to the MAC Aura PXL must be capable
of running at 10/100 Mbps speed, as the fixture does not support Gigabit Ethernet data rates.
DMX
The MAC Aura PXL accepts a DMX-512A data signal.
DMX setup
The DMX address, also known as the start channel, is the first channel used to receive instructions from the
controller. For independent control, each fixture must be assigned its own control channels. If you give two
MAC Aura PXL fixtures the same address, they will behave identically. Address sharing can be useful for
diagnostic purposes and symmetrical control, particularly when combined with the inverse pan and tilt
options.
DMX addressing is limited to make it impossible to set the DMX address so high that you are left without
enough control channels for the fixture.
To set the fixture’s DMX address:
1. Press Enter to open the main menu.
2. Press Enter to enter the DMX ADDRESS menu, then scroll to the desired address and press Enter to
save.
3. Press Menu to exit.
DMX modes
The CONTROL MODE menu lets you set the MAC Aura PXL to one of the fixture’s four DMX operating
modes:
• Compact Mode controls all the fixture’s pixels, Beam and Aura, together as one unit. It offers a
strobe/shutter, 16-bit dimming control, 16-bit RGB control, CTC adjustment, a virtual color wheel, zoom