Harman Martin JEM ZR Series, Руководство пользователя

Страница: 12 / 32

Quick Start
You are no doubt eager to switch on the machine and try it out by making a lot
of fog. This section tells you how to do that. However, please also make the time
to read the safety and servicing instructions in the remainder of this manual.
Setting up
Locate the machine in a suitably large area with nothing in front of the fog
output.
Fill the fluid reservoir with an approved Martin fog fluid as shown on page 22.
Connect a suitably rated power supply to the machine.
The power requirements are:
1200W 240V EU / 1050W 120V US
1550W 240V EU / 1450W 120V US
2100W 240V EU / 1800W 120V US
Now set the mains switch on the rear of the unit, to the ‘ON’ ( I ) position. The
display will show HEAT . If the display shows OFF , press the FOG button on the
control panel or set the RUN MODE to CONTINUOUS . After about 6-8 minutes
the display should show FOG LEVEL (along with the set output level) and the
machine will begin producing fog. If the display shows READY press the FOG
button on the control panel.
Making fog
If you want to adjust the fog density manually, press the Menu < > buttons until
the display shows
FOG LEVEL and use the Value up/down buttons to select a
value above 0% then press the Enter button to store this value.
If no fog is produced it may be necessary to prime the machine. Press
the Menu <> buttons until the display shows PRIME (located in the
SETTINGS submenu), then press the Value Up button so the display
shows YES, then press the Enter button.