Harman Martin ELP CL IP, Руководство пользователя

Страница: 21 / 40

Martin® ELP CL IP User Manual 21
Press MENU to go back up and select a different function to control.
Setting a sequence of scenes
The SHOW menu allows the fixture to store up to 20 scenes internally and display them in a timed
sequence.
SET SCENE TOTALS sets how many scenes will be in the sequence, from 1 to 20.
To store scenes, select EDIT SCENE COLOR and press ENTER. Then use the UP and DOWN
buttons to select the scene number to be edited. Press ENTER. Use the UP and DOWN buttons to
select the color to be set (RED, GREEN, BLUE, LIME, AMBER), then press ENTER and finally
use the UP and DOWN buttons to set the brightness of the color.
The FADE TIME option sets the fade time between scenes, from 0-120 seconds (default 3
seconds).
The HOLD TIME option sets the time each scene is shown for, from 0-600 seconds (default 3
seconds).
Color calibration
From the SERVICE menu you can select CALIBRATION. This menu allows you to adjust the
overall brightness and individual colors of the fixture to match with other fixtures. The fixture is
calibrated in the factory but over time the brightness of the LED emitters will gradually reduce, so
this function can be useful if you need to match a new fixture with older ones.

DIMMER sets the overall maximum brightness of the fixture.

RED, GREEN, BLUE, LIME, AMBER can be made dimmer or brighter from -128 to 127.

LOAD DEFAULTS will load the factory-set calibration values. If you have replaced the factory-
set values with custom values using DEF HQ SET or DEF HO SET (see below) it will load the
custom values.
Because two light quality modes
– high-quality and high-output mode – are available in the
PERSONALITY

QUALITY menu, from software v.1.2 you can adjust the calibration settings of
each mode separately:

DEF HQ SET replaces the factory-set calibration values for high-quality mode with the current
custom calibration values that you have set using the commands listed above.

DEF HO SET replaces the factory-set calibration values for high-output mode with the current
custom calibration values that you have set using the commands listed above.
You must enter a password (019 by default) before you can access these two menu items.
Important! The DEF HQ SET and DEF HO SET commands permanently overwrite the factory-set
calibration values. It is not possible to restore the factory-set values by powering the fixture off and
on, resetting the fixture or uploading new firmware. Once you have saved custom calibration
values using DEF HQ SET and DEF HO SET commands, the only way to return to the original
factory-set values is to re-adjust the calibration settings for the dimmer and the individual colors
back to their original values.