Harman Martin ELP CL IP, Руководство пользователя

Страница: 11 / 40

Martin® ELP CL IP User Manual 11
Physical installation
Warning!
Read ‘Safety information’ on page 5 before installing the fixture.
Warning! The safety and suitability of lifting equipment, installation location,
anchoring method, mounting hardware and electrical installation are the
responsibility of the installer. All local safety regulations and legal requirements
must be observed when installing and connecting the fixture. Installation must be
carried out by qualified professionals only.
Contact your Martin supplier for assistance if you have any questions about how to install this
product safely.
Fixture location
The ELP CL IP fixture is IP65-rated. It can be used in indoor and outdoor locations. Do not
immerse or expose to high-pressure water jets. The fixture requires free and unobstructed airflow
around it to ensure adequate cooling.
Observe the following limitations in selecting a location:

Respect the precautions listed under
‘Safety information’ on page 5.

Do not locate the fixture in an unventilated space.
Warning! See drawing on right.
Lenses can focus sunlight and strong
light, presenting a risk of fire and
damage to the fixture, creating a
potential fire hazard and causing
damage. Position or shade the head
so that the front lens will not be
exposed to sunlight or another strong
light source from any angle
– even for
a few seconds.
Important! Do not point the output from other lighting fixtures at the fixture, as powerful light can
damage the display.
Harsh environments
The ELP CL IP has a rugged construction and is designed to withstand such outdoor conditions as
high and very low temperatures, heavy rain, etc. However, it is not designed for use in extreme
environments such as air with a high content of salt, chlorine, acid or other corrosive agents.
Exposure to harsh environmental conditions like these may result in deterioration of the product
that is not covered by the product warranty.
Mounting the fixture
Warning! All fasteners used to mount ELP fixtures must be strong enough to
hold the fixture safely. They must also be suitable for the application and
environment. Install a washer directly under the head of each fastener when
anchoring the mounting bracket to the installation surface.
Fastening the fixture to a flat surface
The fixture can be fastened to a hard, fixed, flat surface in any orientation. Ensure that the surface
and all fasteners used can support at least 10 times the weight of all fixtures and equipment they
will support.
Fasten the fixture securely. Do not stand it on a surface where it may fall over. If you install the
fixture in a location where it may cause injury or damage if it falls, secure it as directed below with
a securely anchored approved safety cable that will hold the fixture if the primary fastening method
fails.