10
N
0
585/ N
0
585.5 INTEGRATED AMPLIFIER
/
OWNER’S MANUAL
SSP SETUP
In the past, the differing number of channels in each component
made integration between two-channel and multichannel
components difficult. Sending multichannel processor output
signals to a stereo Preamplifier distorts calibrated processor
output levels. Multichannel processor volume controls adjust
the relative volume level of all channels in unison. However,
stereo Preamplifier volume controls adjust the relative volume
level of just the front left and right channels, leaving the center,
surround, and subwoofer channels unaffected.
To avoid these problems when the N
0
585 is connected with an
associated surround-sound processor, the SSP mode allows
selected input sources to pass through the N
0
585 without
interference. When SSP mode is activated the N
0
585 volume
control is deactivated to prevent the N
0
585 from distorting
channel balance. As a result, the processor controls the relative
volume level of all channels while maintaining its calibrated
output levels.
To connect the N
0
585 with a surround-sound processor (see
illustration on next page):
1. Make sure the N
0
585 and all associated components are
powered off and disconnected from electrical outlets.
2. Connect the output connectors on the surround-sound source
component to the input connectors on the surround-sound
processor. For example, if the source component is a Blu-ray
disc player, connect it to the appropriate input connectors on
the surround-sound processor.
3. Connect the front left and right output connectors on the
processor to the desired input connectors on the N
0
585.
For best performance, use balanced connections whenever
possible.
4. Connect the center, surround, and subwoofer output
connectors on the processor to the appropriate input
connectors on the power amplifier(s).
5. Connect the N
0
585’s speaker outputs to the system’s front left
and right (main) speakers.
To activate the SSP mode for a selected input:
CAUTION: Before activating the SSP mode for any input, set
the associated surround sound processor volume control to a
reasonable level to prevent sending dangerous signal levels to
the associated loudspeakers.
1. Activate the Setup menu by pressing the Setup button.
2. Select Input Setup, and press Enter.
3. Select the input you wish to configure for SSP use, and press
Enter.
4. Select SSP, and press Enter.
5. Set the SSP parameter to On.
6. Press the Setup button four times to step backward through
the menu hierarchy and exit the Setup menu.
SSP SETUP