Harman Advance 1, Инструкция по установке и эксплуатации

Страница: 22 / 44

2 2
1 -9 0 -0 9 7 3 0 R 2 6 _ 0 6 /1 3
Opening:
The view door must be opened for cleaning of the glass and
scraping of the burn pot. This should be done with the unit off
and cool, in most cases. Although the glass can be cleaned
and burn pot scraped while the unit is at low burn.
1. Lift the door latch forward and up.
NOTE: Door latch may
be hot.
ig. 2
2. Swing the door open to the left, stopping the swing when
resistance is felt. orcing the door open further than it is
designed, may cause damage to the door or it s hinges.
Top Glass Clip
Side Glass Clip
Nuts
Btm Glass Clip
Side Glass
Window Gasket
Door Assembly
ig.
ig. 2
Receiving Bolt
WARNING
Door latch
may be hot!
Maintenance - Cleaning G lass on V iew Door
CAUTION
n t put e ce e n ar pre ure n t e n e
side of the door while in the open position.
If the door is going to be opened for an extended period
of time, it is suggested that it be removed. See Removing
iew oor section below.
. Inspect the door gasket and glass gaskets for worn or
missing pieces. Replace if necessary. ( ig. )
Closing:
When closing the door, always hold the door latch all the way
up until it has caught the receiving bolt. Then push the latch
downward and back until the door is fully seated.
R emoving V iew Door:
To remove the view door from the stove, hold the door by
the bottom and lift upward, off of the hinge pins. See ig.
The glass in your Harman® stove is a special ceramic glass.
DO NOT abuse the glass by striking or slamming shut.
Never burn the appliance if the door glass is cracked or
broken.
R eplace only with Harman® supplied 5mm ceramic glass.
W AR NING - o NOT Use Substitute aterials.
Clean the glass with a soft cloth and mild glass cleaner. o
not clean the glass when hot, and avoid the use of abrasive
cleaners.
G lass replacement:
Carefully remove all remaining glass and gasket materials
prior to replacing the glass.
Lay the door face down on a flat surface. Remove the glass
retainers and screws. Apply the gasket material to the face
of the new glass. Lay the glass into the door. Lay the glass
retainers into position and install the nuts. Tighten each nut
evenly, to avoid making any stress points.
ig.