ENGLISH
FM INDOOR ANTENNA
Select the FM antenna that best
meets your needs:
1. An indoor dipole antenna is
supplied with your TU950 (#1).
Connect it to 75
Ω
FM Antenna
input using the supplied 300
Ω
/75
Ω
adapter as shown on the Rear
Panel Connections diagram. This
will work well if you are located in
a strong signal area but it may be
necessary to change the position
of the antenna until you get the
best reception of your favorite
stations. Make certain that the half
wave antenna is extended to its full
length.
2. Other optional indoor antennas are
available from your dealer. They
may improve reception by offering
greater positioning flexibility.
3. If reception is unsatisfactory using
indoor antennas, an outdoor
antenna should be installed (#2).
Disconnect the indoor antenna
before replacing it with an outdoor
one. Use the 300
Ω
/75
Ω
adapter if
the lead from the antenna is 300
Ω
twin lead wire.
4. The TU950 may also be connected
to the FM service of a cable
antenna system.
AM ANTENNA
The TU950 comes with an MW/LW
antenna (#3) that provides good
reception in most locations. Connect
this antenna to the screw terminals
marked “AM ANTENNA” as shown on
the rear Panel Connections diagram.
For best reception, place the antenna
away from the unit as well as from
sources of RF emissions such as a
television or computer. It should also
be placed away from contact with
any metal object.
In areas where MW/LW signals are
weak, an outdoor antenna may
improve sound and reception quality.
Connect the antenna as shown in the
Rear Panel Connections diagram
making certain to also connect a
ground wire to the “GND” terminals.
CONNECTION TO
PREAMPLIFIER OR
INTEGRATED AMPLIFIER
Using the cable provided, connect
the left and right OUTPUT jacks on
the back of the TU950 to the TUNER
input on your preamplifier or
integrated amplifier (#6). Be certain to
observe proper channel connections
using the color coded cables and
connectors so that red connects right
channels and white connects left
channels. To avoid the possibility of
intermittent sound and possible
damage to your speakers, be certain
to push the plug all the way into the
jacks.
NOTE: Before making any audio
connections, unplug all components
of your audio system from their AC
power outlets. To reduce the
possibility of hum and/or noise in
your system, place all audio
interconnection cables away from
both AC power cords and speaker
wires.
REMOTE IN / OUT JACKS
Using the REMOTE IN/OUT jacks it is
possible to control the UP/DOWN
tuning, BAND and PRESET functions
of the TU950 when it is used with a
Harman Kardon remote controlled
amplifier. Connect the REMOTE IN
jack of the TU950 to the REMOTE
OUT jack of another Harman Kardon
product as shown on the Rear Panel
Connections diagram (#7). Use the
remote provided with the amplifier by
pointing it at the amplifier, not the
TU950. If you have additional Harman
Kardon components, you may
continue the remote control
connection by running a wire from the
TU950 REMOTE OUT jack to the
REMOTE IN jack of the next
component to be connected.
AC POWER CORD
Plug this cord (#8) into an AC main
outlet or to the switched AC outlet on
the rear of your amplifier.
8
Rear Panel Connections
TU950 230V-eng 11/01/98 15:18 Side 8
