Harman Kardon DVD 25, Руководство по обслуживанию

Страница: 18 / 48

II) Open DVD25 and remove the original KIT500 Mechanism
Remove the top cover (9 Phillips screws).
Remove the original KIT500 Mechanism (4 Phillips screws holding the mechanism to the chassis, and unplug
the two flat cables and power supply cable from the Main PCB.)
Remove the colored front faceplate from the mechanism by lifting it up and off front of the tray; save the
faceplate and discard the mechanism and cables.
III) Attach single 29 pin flat cable and Power Supply cable to new Mechanism KIT 710.
(Caution – assure the conector-side of the flat cable matches the connector-side of the female receptacle)
Re-attach the front faceplate to the new mechanism.
IV) Elevate and mount the new KIT 710 mechanism
by using 3 new washers under each foot; then fasten
the mechanism with 4 new m3x12 screws. Align KIT710 with the opening in the front panel before tightening
screws completely.
V) Place (4) cushions adhesive-side on the bottom corners of the new PC board, and place it in the
recommended position in the chassis. Its position should match the illustration(s).
Plug all three new flat cables into the new PC board (including 29 pin cable from the mechanism).
(Caution – assure the conector-side of the flat cables match the connector-side of the female receptacles)
Plug the Power Supply cable into connector J5 on Main PCB.
Initial Final
(Note: Main PCB normally present has been removed for clarity)
18
DVD25/DVD101
harman/kardon