Signature 2.0
The first step to correct this problem is to turn the 2.0 off using the
Master Power Switch
and unplug the unit from the AC wall outlet and
wait at least three minutes. After the pause, reconnect the AC power
cord and turn the unit on again. If the system still malfunctions, a system
reset may clear the problem. To reset the system, press the
Menu
button to view the
Setup
Menu. Press the
Menu Control
button until
Advanced Setup
is highlighted. Press the
Menu Control
button to go to
the next screen. At
the Advanced Settings
menu, press the
Menu
Control
button twice until
SYSTEM RESET
is highlighted. Press the
Menu Control
button again. This will bring up the
System Reset
Menu.
If you wish to exit at this point, press the
Menu
button. To proceed with
the reset, press the
Menu Control
button to move the highlighted area
to the
Yes
line, and then press the
Menu Control
button. The next
screen instructs you to proceed by pressing and HOLDING the
Store
button until the reset is complete. Follow that instruction by holding the
Store
button until the Reset Completed message appears briefly on
screen and the front panel
Information Display
. This is your indication
that the reset has been accomplished, and you may release the
Store
button. The system will automatically return to the
Advanced Settings
menu. After a reset the system is returned to the original factory default
settings, the microprocessor system is re-initialized. Press the
Menu
button twice to return to normal operation.
JBL
Model Instructions
Comment
DCR600
To correct this problem, first unplug the unit from the AC wall outlet and
wait at least three minutes. After the pause, reconnect the AC power
cord and check the unit’s operation. If the system still malfunctions, a
system reset may clear the problem. To clear the DCR600’s entire
system, first put the unit in Standby by pressing the
System Power
Control
button. Next, press and hold the
Tone Mode
and the
FM Mode
Selector
buttons for three seconds. The unit will turn on automatically
and display the
RESET
message in the Main Information Display
DCR600II
To correct this problem, first unplug the unit from the AC wall outlet and
wait at least three minutes. After the pause, reconnect the AC power
cord and check the unit’s operation. If the system still malfunctions, a
system reset may clear the problem. To clear the DCR600II’s entire
system, first put the unit in Standby by pressing the
System Power
Control
button. Next, press and hold the
Tone Mode
and the
FM Mode
Selector
buttons for three seconds. The unit will turn on automatically
and display the
RESET
message in the Main Information Display
DVD600
In the event that you forget the password for the DVD600, you may reset
it to the factory default by following this procedure: In Standby mode,
press the
Search Back
and
Skip Forward
buttons on the front panel
simultaneously for more than 3 seconds. The
Information Display
will
light, and a test pattern will appear on your TV. Press
Power On
to
proceed.
PASSWORD RESET ONLY
DVD600II
In the event that you forget the password for the DVD600II, you may
reset it to the factory default by following this procedure: In Standby
mode, press the
Search Reverse
and
Skip Forward
buttons on the
front panel simultaneously for more than 3 seconds. The
Information
Display
will light, and a test pattern will appear on your TV. Press the
System Power Control
to proceed.
PASSWORD RESET ONLY
