Harken Performa 20 STP, Руководство по установке и обслуживанию

Страница: 9 / 15

9 Performa
™
Winch
20 STP
Installation and Maintenance Manual
If it is necessary to replace any
jaws of the winch, proceed as follows:
If it is necessary to remove any pawls in the central shaft, proceed as follows:
Once the winch is completely disassembled, clean the parts: use a basin of diesel oil to soak
metal components and rinse plastic parts in fresh water. Once you have done this, dry the parts
with cloths that do not leave residue.
Inspect gears, bearings, pins and pawls for any signs of wear or corrosion.
Carefully check the teeth of gears and ring gears to make sure there are no traces of wear.
Replace worn or damaged components.
Carry out maintenance on components using the products listed below.
For more information on which products to use where, refer to the exploded diagram below.
Use a brush to lightly lubricate all gears, gear pins, teeth and all moving parts with grease.
Lightly lubricate the pawls and springs with oil. Do not use grease on the pawls!
I. Unscrew the 3 screws n°14
( 4Nm/35 in-lb)
Unscrew the screw n°10 and remove
the washer n°9 ( 4Nm/35 in-lb)
II. Remove the jaws n°19