Harken CLR 1200, Руководство по установке и обслуживанию

Страница: 35 / 59

35
CLR Mooring Winch
Installation and Maintenance Manual - Mod.A
9.2 Maintenance products
The maintenance products listed below must be used:
1. Strong threadlocker – Green (i.e. LOCTITE® 270)
Clean the parts and apply the product, spreading it all over the thread as shown.
Assemble the parts and wait at least 45 minutes before use. To remove screws sealed with
threadlocker, you may need to heat the parts to reduce the effect.
4. Synthetic GREASE Harken - BK4513
Apply a film of grease with a brush to all the parts indicated, and make sure that the film
is visible. Take special care when greasing the teeth of the ring gears, the gears and the
roller bearings.
It is important to keep the teeth of the ring gears of our winches greased to increase their
efficiency and life.
WARNING!
Parts and especially the gears of the winch that are not sufficiently greased will
undergo irreversible wear that is not covered by the warranty.
2. Medium threadlocker – Blue (i.e. LOCTITE® 243)
Clean the parts and apply the product, spreading it all over the thread as shown.
Assemble the parts and wait at least 45 minutes before use.
Generally, for use on all screws, requires no heating before removal.
5. Anti-corrosive lubricants (i.e. TEFGEL®)
Apply sacrificial anodes or anti corrosive lubricants to prevent electrolytic corrosion
between different metals in contact with one another.
NOTE! Apply the anti-corrosive lubricant with a brush on clean surfaces.
6. Anti-seizing (i.e. SAF-T-EZE® Anti-Seize or LANOCOTE®)
This product is used to prevent problems of seizing caused by oxidation.
We recommend using this or similar products on stainless steel screws where the
use of Loctite is not specifically requested.
NOTE!
Apply the anti-seize with a brush.
7. Vaseline OIL
This product is used to lubricate balls and roller bearings.