CB + Cars can Convert to Fit Old-Style, Non-CB Track
Important! Requires CB+ cars. See complete instructions at www.harken.com/manuals.
Converting CB + Cars to Run on Non-CB Track
3. Remove retaining clips and
corner keepers over box to
catch balls
.
1. Use flat-bladed screwdriver
to push retaining clip
toward end.
5. Remove two (2) clips
from car loader. Slide car
loader in so loading port
is on the side of car
without balls.
2. Pry retaining clip off and
dump balls in box.
4. Hold car on edge and load
lower side with correct
number of balls. Do not
overload. Consult chart
to confirm
quantity.
6. Put one (1) clip on "open"
end of loader. Load rest
of balls through ball loading
port into empty bearing
race. Consult chart to
confirm quantity. Line up
car loader with track and
gently roll car onto track.
Do not use corner keepers.
CB+ cars designed for CB track.
CB+ cars can convert to run
on old-style, non-CB track.
Track built after 2003. No need to convert car.
Track built through 2003.
Groove for
retaining clip
CB track
Non-CB track
Order car loader.
Car length Loader
5 3/8" 136 mm HBB1
7 7/16" 188 mm HBB28
