5
DIMENSIONS & MOUNTING
54.0mm
45.2m
m
52
.1
mm
73.2mm
63.6m
m
END-MOUNT LEGS
UNDER-MOUNT
(SLIDING) LEGS
DUAL MOUNTING OPTIONS
Your Hyperion Series light bar comes with both end-mount and under-mount (sliding) legs in the box.
You can use whichever legs suit your application best.
END-MOUNT LEGS
• Fasten the end-mount legs to the bar using the included spring washers and 8mm x 14mm hex bolts,
but do not tighten all the way (you may need to adjust the angle later).
• Attach the end-mount legs to the bar using the included M8 x 25mm bolts and nuts.
UNDER-MOUNT (SLIDING LEGS)
• Insert the M6 x 20mm bolts into the middle channel at the rear of the bar and then slide them
towards the middle. You will notice that this channel widens at the end of the bar just enough to
accept the bolt heads.
• Slide the square washers over the ends of the bolts, ensuring that the two raised edges face forward
and sit inside the top and bottom channels.
• Attach the under-mount legs to the bolts by inserting the end of the bolt through the slotted hole in
the leg. Ensure that the leg curves underneath the bar, not away from the bar.
• Secure the under-mount leg to the bar with the M6 nut, but do not tighten all the way (you may
need to adjust the angle later).
• Attach the under-mount leg to the bar using the included M8 x 25mm bolt and nut.
