HARDKORR BZRX Series, Инструкция по эксплуатации и руководство по установке

Страница: 6 / 12

6
INSTALLATION
INSTRUCTIONS
• Prior to installing the lights on your vehicle, Hardkorr recommends
testing the lights and wiring harness outside of the vehicle.
• Disconnect the battery.
• If you do not have pre-drilled holes, sit the lights on the mounting
surface, mark where the holes will need to be placed, and then remove
the light and drill the holes. There are three mounting holes in each
bracket; you can choose to use either one or three bolts per light. Using
three bolts may provide additional stability in extreme conditions.
• Mount the bottom plate of the bracket through to the bullbar, roof rack
or other surface, with the rubber pad in-between.
• Connect the 3-pin Deutsch (triangular plug) cable from the LED lights to
the matching plugs on your Hardkorr wiring harness.
• Connect the white wire to the twin fuse adaptor, then remove the
accessories fuse in the fuse box. Plug the accessories fuse as well as the
supplied fuse into the adaptor, then insert the adaptor into the fuse box
slot from where you removed the accessories fuse.
• Remove the high beam plug from the back of your headlight and
connect it to the piggyback adaptor - the kit has a H3 and H4 adaptor
supplied, however other adaptors are available for purchase separately
if your vehicle has a different plug (note that some vehicles require a
model-specific puggyback adaptor). You’ll then need to connect the
adaptor to the white plug on the harness.
• Next, feed the switch to the inside of the cabin. This should be through
a rubber grommet that runs through the firewall. To do this, you’ll need
to note the order of the wires on the back of the switch, then remove,
reconnecting once in the cabin of your vehicle.
• Secure the relay to the body of the vehicle then connect the positive and
negative terminals from the harness to your battery.