HARDKERNEL ODROID-XU4, Руководство пользователя

Страница: 72 / 92

67
ODROID-XU4 USER MANUAL
most recent (3.10.92+) Linux images. No new software needs to be
installed. It has not been tested under any Android version. The en-
closure required its own 5V/4A power source (purchased separately),
since the XU4 cannot provide the peak startup power requirements of
the enclosure via the USB3 port.
Please note that Hardkernel does not endorse or support this
enclosure and cannot be expected to provide help with its use on the
XU4. This enclosure is mentioned here only to satisfy your experi-
mental curiosity and no guarantee is offered. Your luck in getting to
use unsupported devices such as this enclosure with an XU4 may
vary. The details of the enclosure may be discovered with the follow-
ing command:
$ lsusb
...
Bus 004 Device 003: ID 067b:2775 Prolific Technology, Inc.
Bus 004 Device 002: ID 05e3:0616 Genesys Logic, Inc.
...
T
he first entry reflects the RAID controller, and the second entry
reflects the USB3 controller used in the enclosure. The image below
shows the setup using two (2) PNY XLR8 240GB SSDs in a RAID1
setup, with the enclosure cover removed to show internal details.
XU4 with two SSDs in a RAID1 setup
Make sure to follow the instructions provided along with the en-
closure packaging in order to configure it for a RAID1 setup. As al-
ways, follow the standard procedure of shutting down power to the
XU4 and peripherals before attachment and detachment. Power up
the peripherals (if they have their own power supplies) before turning
the power to the XU4, so they can be detected. Improper usage could
damage the XU4.
After power up, follow the HDD/SSD partition setup instructions
in the previous section. In this example, the partition was labeled
Chapter 4