Hardi HC 6500, Инструкция, Страница: 46 / 92

7 - Menu 3 Calibration
7.4
Menu 3.2.2 Nozzle method
During practical flow calibration the individual nozzle output on the
display is compared to the actual individual nozzle output. The output
displayed is corrected to read the actual output.
μ
ATTENTION! See menu [3.3 Boom] if no boom data has yet been entered.
Method:
1.
Open all boom sections. Switch the main ON/OFF to ON. Close End nozzles (if fitted).
2.
Go to menu [3.2.2 Nozzle method].
3.
Press #. The display will then show the individual nozzle output per minute.
μ
ATTENTION! If a section has not been opened or an End nozzle is not closed, a warning will show up in the largest
window on the display.
4.
Using a
HARDI®
calibration jug, check the actual nozzle output per minute. It is recommended that an average of
several nozzles be taken.
5.
Press #.
6.
Correct the output shown on the display with the ¿ or ª keys or use the numeric keys to read the average output
measured with the calibration jug.
7.
Press # to see the new value.
8.
Press # again to accept the value.
Menu 3.2.3 Tank method
During practical flow calibration, the tank is partly emptied through the
nozzles. While emptying, the display calculates the quantity emptied on
the basis of the actual calibration value (PPU). The quantity displayed is
compared with the quantity actually dosed.
This can be done using the tank contents level indicator or by 3.2.3.1
Tank method weight difference before and after. The quantity displayed
is corrected to read the quantity actually dosed.
3.2.2.1 Nozzle method
4 .00
fluid oz/min
Measure the flow per minute from a number of nozzles.
Press Enter
3.2.3.1 Tank method
0 .00
gallon
The sprayed amount is counted up when the sections are
opened